Support User Manuals

Sierra Wireless 20070914 Cell Phone User Manual

Open as PDF

of 203

Configuration Commands

Rev 3.0B Feb.08 147

• n=minutes

*TPORT=n

Setsorqueriestheportusedfor theATTelnetserver.If0is

specified,theATTelnetserverwillbedisabled.Thedefault

valueis2332.

• n=0:Disabled.

• n=1‐65535

Tip: Many networks have the ports below 1024 blocked. It is recom-

mended to use a higher numbered port.

*TQUIT

Disconnectsthetelnetsession.NotavailableinAceManager..

Low Power

ThePinPointXwillputitselfintoalowpowerusingmode

whenconfiguredeventsoccur.LowPowermodeisessentially

astandbymodewhichusesminimalpowerwhilebeingready

to“comealive”quickly.

Figure 1-16: AceManager : Low Power

PTMR=n

Numberofminutesafteroneofthepowerdownevents(VTLG

orDTRP)happensuntilthePinPointXentersthelowpower

mode.IfDTRPandVLTGareboth0(zero),thissettingdoes

nothing.

• n=0‐255minutes

Note: There is always a minimum of 1 minute between power down

event and actual shutdown (to give the PinPoint X time to prepare);

entering zero will not power down the modem immediately, but after

previous next