Support User Manuals

Sierra Wireless 20070914 Cell Phone User Manual

Open as PDF

of 203

Configuration Commands

Rev 3.0B Feb.08 155

*PPMINTIME=n

Specifiestheminimumamountoftimebetweenreports

generatedduetoeitherthetimeinterval(*PPTIME)orthe

distanceinterval(*PPDIST).Thisisusefultolimitnetwork

trafficandmakemoreefficientuseofbandwidth.Thiscanbe

usedinconjunctionwithstoreandforward.Theminimum

valuewhichthissetting

cantakedependsonthepoliciesofthe

carrier.

• n=0:Disabled

• n=1‐65535seconds

*PPODOM=n

Enableodometerreporting.

• n=0:Disabled(default)

• n=1:Enabled

*PPODOMVAL=n

ThecurrentodometervalueofthePinPointX.Thevalueisin

meters.Maximumvalueisapproximately4.3billionmeters

(2.5millionmiles).1mileisapproximately1600meters.

• n=meters

*PPPORT=n

PortwhereGPSreportsaresent.

• n=1‐65535

*PPREPORTINPUTS=n

Enableinputreporting.

• n=0:Disabled

• n=1:Enabled

Note: If both AT*PPCOM1000=1 and AT*PPREPORTINPUTS=1 are

enabled, the PinPoint X digital inputs will be reported and the

COM1000 inputs will be ignored.

*PPSIMPLETO=n

Definesthelinearback‐offbasenumber.Notavailablein

AceManager.

• n=0:Disabled

• n=5‐255

previous next