Filter
Top Products
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––– Message Waiting
Features 69
[PhDN/MW] Message Waiting
To use this feature, your telephone must be programmed for both [PhDNs] and Message
Waiting (
0:) buttons.
Your telephone has one built-in Message Waiting (
0VJ) button that works with your [PDN]
(see Message Waiting for a detailed explanation of this feature.).
➤ To set a Message Waiting indication for a [PhDN/MW]
➤ Follow the same procedure used to set a message light on another telephone.
➤ To respond to [PhDN/MW]
➤ To cancel Message Waiting set on a [PhDN/MW]
A flashing
[PhDN/MW] indicates that there is a message waiting on that button; however, if
you have listened to that message (which should turn the LED off) or if for some reason you
wish to turn it off, you can follow the steps below to turn it off.
1. Press the [PhDN/MW]
indicated by the flashing red
LED.
...or answer a message by
pressing
7$/..If there is no
answer, hang up and try at a
later time.
Your telephone rings the station or voice mail device
that left the message. (The LED on your telephone
continues to flash.)
2. Press
7$/. after receiving
the message.
If you have more than one message waiting indication
from different sources, the red LED continues to flash,
after you answer the first message.
3. Repeat Steps 1 and 2 to
answer the next messages.
1. Press the [PhDN] associated
with the flashing.
You hear a steady dial tone and the
[PhDN] LED
lights steady.
2. Enter
. The dial tone stops.
3. Press
7$/.. The flashing red Message Waiting LED stops,
indicating that the message has been canceled.