Filter
Top Products
IP Office Basic Edition - Quick Mode 9500 Series Phone User Guide Page 11
- Issue 6b (23 November 2011)IP Office Basic Edition
Introduction: Dialing Codes
1.4 Feature Codes
The following feature codes can be dialed from most phones after pressing Feature. Most of these features can also be
assigned to programmable buttons.
Feature
Code
Description
Do Not Disturb
01
This function allows you to switch do not disturb on or off.
" Cancel
01
Recall
03
This function allows you to send a recall or hook flash signal.
Save Number Redial
04
This function allows you to save the number dialed during a call and to redial that
number when idle. This can be used when the number dialed does not answer.
Last Number Redial
05
This function allows you to redial the last external number dialed.
Conference Drop
06
This function allows you to select and drop a call from a conference.
Privacy
07
This function allows you to turn privacy on or off. When on, other extensions are not
able to bridge into your calls.
Call Forward
11
This function allows you to redirect all your calls to another number. If the system
administrator has configured your for Remote Call Forwarding, you can forward calls
externally by specifying a personal speed dial as the destination.
Call Forward Cancel
11
Account Code Entry
12
This function allows you to enter an account code prior to making a call or during a
call.
Voice Mailbox
Transfer
14
This function allows you to transfer your current call to another extension's mailbox.
Your current call is put on hold and you enter the target extension number to indicate
the mailbox required.
VMS Cover
15
This function allows the you to switch use of voicemail coverage for your extension on
or off.
Caller ID Name
Display
16
This function allows you to swap the display of caller ID name and number information
on the phone.
Caller ID Inspect
17
This function allows you to see the caller ID of a call on another line without
interrupting the current call to which you are connected.
Call Coverage
20
This function allows you to switch call coverage on or off. When on, any calls to you
that ring unanswered also start ringing at your call coverage extension.
Station Lock
21
This function allows you to lock and unlock your extension from being used to make
calls. When selected, you are prompted to enter a four digit code after which the
extension is locked. If the extension is already locked, use of this function prompts for
reentry of the four digit code to unlock the extension.
Station Unlock
22
This function can only be used by the first two extensions in the system. It allows the
user to unlock any extension without needing to know the code that was used to lock
that extension.
Caller ID Log
23
This function allows you to view the phone system's call log of all caller IDs of calls
received by the system. To use this you must be one of the three extensions
configured for call ID logging by your system administrator.
Hot Dial
26
This function allows you to dial a stored number without first going off hook or
pressing the SPEAKER button.
Absent Message
28
This function allows you to set or clear an absent message for display on you phone.
When set, the absent message is also displayed on other extensions when they call
the user.
Contact Closure 1
41
This function you to operate the system's contact closure 1 or 2 connection. To use
this you must be a member of the system's contact closure group.
Contact Closure 2
42
System Release
590
Displays the core software level that the system is running.
System IP Address
591
Displays the IP address of the systems LAN port.
36
36
16
25
27
31
31
35
24
41
32
34
34
30