Filter
Top Products
Section 2
12 Getting to Know Your Sprint PCS Phone
Removing the Battery
Before you remove the battery, make sure the phone is off.
To remove your battery, follow these steps:
Charging the Battery
Your Sprint PCS Phone comes with a rechargeable Lilon battery, which is
partially charged when you receive the phone. Fully charge the battery
before using the phone.
÷
Connect the AC Adapter to the proper connector
on the bottom of the phone as shown, then
connect the adapter’s plug to a wall outlet.
Keeping track of your battery’s charge is important.
If your battery level becomes too low, your phone automatically turns off.
The battery charge indicator ( ) is located in the upper-right corner
of your phone’s display screen. If the battery charge gets too low, the
indicator blinks and the phone sounds a warning tone.
Note: You must have at least a partial charge in the battery to make or
receive calls, regardless of whether or not the AC Adapter is connected to
the phone. The battery indicator is animated as the battery is charging.
The battery is fully charged when the battery indicator looks like .
You can safely recharge the battery at any time, even if it has a partial
charge.
Warning! Always use Sprint PCS approved battery chargers. Using the
wrong charger could cause damage to your phone and void the warranty.
1. Hold the phone face down,
place your thumb in the
groove on the back of the
phone and slide the battery
door down.
2. Lift the battery
door off the
phone.
3. Lift and slide
the battery out
of the phone.