Filter
Top Products
User Guide for Kyocera KX440 Series Phones iii
FCC/IC Notice
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
To maintain compliance with FCC RF exposure
guidelines, if you wear a handset on your body, use
the Kyocera Wireless Corp (KWC) approved case
CA90-B1860 or holster 55-B1795-02.
Other accessories used with this device for body-
worn operations must not contain any metallic
components and must provide at least 25 mm
separation distance, including the antenna, and the
user’s body.
THIS MODEL PHONE MEETS THE GOVERNMENT’S
REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
Your wireless phone is a radio transmitter and
receiver. It is designed and manufactured not to
exceed the emission limits for exposure to radio
frequency (RF) energy set by the Federal
Communications Commission of the U.S.
Government. These limits are part of
comprehensive guidelines and establish permitted
levels of RF energy for the general population. The
guidelines are based on standards that were
developed by independent scientific organizations
through periodic and thorough evaluation of
scientific studies. The standards include a
substantial safety margin designed to assure the
safety of all persons, regardless of age and health.
The exposure standard for wireless mobile phones
employs a unit of measurement known as the
Specific Absorption Rate, or SAR. The SAR limit
set by the FCC is 1.6 W/kg.* Tests for SAR are
conducted using standard operating positions
specified by the FCC with the phone transmitting at
its highest certified power level in all tested
frequency bands.
Although the SAR is determined at the highest
certified power level, the actual SAR level of the
phone while operating can be well below the
maximum value. This is because the phone is
designed to operate at multiple power levels so as
to use only the power required to reach the
network. In general, the closer you are to a wireless
base station antenna, the lower the power output.
Before a phone model is available for sale to the
public, it must be tested and certified to the FCC
that it does not exceed the limit established by the
government-adopted requirement for safe
exposure. The tests are performed in positions and
locations (e.g., at the ear and worn on the body) as
required by the FCC for each model. The highest
SAR values for this model phone are:
Cellular Band (Part 22)—Head:1.36 mW/g;
Body-worn: 0.584 mW/g with KWC universal belt
clip 55-B1795-02;
Face: 0.397 mW/g with at least one inch
(2.5 cm) separation.
PCS Band (Part 24)—Head:1.46 mW/g;
Body-worn: 0.311 mW/g with KWC universal belt
clip 55-B1795-02;
Face: 0.22 mW/g with at least one inch
(2.5 cm) separation.
Recommended body worn accessories are only
intended for use with the standard or thin battery
door, not the sport clip.
(Body-worn measurements differ among phone
models, depending upon availability of accessories
and FCC requirements. The body-worn SAR
values provided above were obtained by using
Kyocera Wireless Corp. (KWC) approved case
CA90-B1860 or holster 55-B1795-02. The sport
clip is not designed to be a body-worn accessory).
While there may be differences between the
SAR levels of various phones and at various
positions, they all meet the government
requirement for safe exposure.
82-K5873-1EN.book Page iii Monday, May 24, 2004 9:38 AM