Filter
Top Products
Settings
107
Prompt password—If you must enter the password every
time you log in to a server, or if you do not want to save
your password in the device, select Yes.
Password—A password may be needed to make a data
connection, and is usually provided by the service provider.
Authentication—Select Normal or Secure.
Homepage—Depending on the access point you are setting
up, enter the web address or the address of the multimedia
messaging center.
Select Options > Advanced settings to change the
following settings:
Network type—Select the internet protocol type to use:
IPv4 or IPv6. The other settings depend on the selected
network type.
Phone IP address (for IPv4 only)—Enter the IP address of
your device.
DNS address—In Primary DNS address, enter the IP
address of the primary DNS server. In Secondary DNS
address, enter the IP address of the secondary DNS server.
Contact your internet service provider to obtain these
addresses.
Proxy server address—Define the address for the proxy
server.
Proxy port number—Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data connection—If you select When available
and you are in a network that supports packet data, the
device registers to the packet data network. Starting an
active packet data connection (for example, to send and
receive e-mail) is quicker. If there is no packet data
coverage, the device periodically tries to establish a packet
data connection. If you select When needed, the device
uses a packet data connection only if you start an
application or action that needs it.
Access point—The access point name is needed to use
your device as a packet data modem to your computer.
Data call
The data call settings affect all access points using a GSM
data call connection.
Online time—Set the data calls to automatically
disconnect after a time-out if there is no activity. To enter
a time-out, select User defined, and enter the time in
minutes. if you select Unlimited, data calls are not
automatically disconnected.