Filter
Top Products
Copyright
©
2005 Nokia. All rights reserved.
Tools
108
Automatic redial—Select On, and your phone makes a
maximum of ten attempts to connect the call after an
unsuccessful call attempt. To stop automatic redialling,
press .
Summary after call—Activate this setting if you want the
phone to briefly display the approximate duration of the
last call.
Speed dialling—Select On, and the numbers assigned to
the speed dialling keys ( - ) can be dialled by pressing
and holding the key. See also "Speed dial a phone number",
p. 27.
Anykey answer—Select On, and you can answer an
incoming call by briefly pressing any keypad key, except
, , , and .
Line in use ( )—This setting is shown only if the SIM
card supports two subscriber numbers, that is, two phone
lines. Select which phone line you want to use for making
calls and sending text messages. Calls on both lines can be
answered irrespective of the selected line. If you select
Line 2 and have not subscribed to this network service, you
will not be able to make calls. When line 2 is selected,
is shown in the standby mode.
Tip! To switch between the phone lines, press and
hold in the standby mode.
Line change ( )—To prevent line selection, select Line
change > Disable if supported by your SIM card. To change
this setting, you need the PIN2 code.
Connection settings
Data connections and access points
Your phone supports packet data connections ( ), such as
GPRS in the GSM network.
Glossary: General packet radio service (GPRS) uses
packet data technology where information is sent in
short packets of data over the mobile network.
To establish a data connection, an access point is required.
You can define different kinds of access points, such as:
• MMS access point to send and receive multimedia
messages
• Access point for the Web application to view WML or
XHTML pages
• Internet access point (IAP) to send and receive e-mail
Check the type of access point you need with your service
provider for the service you wish to access. For availability
and subscription to packet data connection services,
contact your network operator or service provider.