Filter
Top Products
Messaging
90
If you select Multimedia retrieval > Always automatic,
your device automatically makes an active packet data
connection to retrieve the message both in and outside
your home cellular network.
Allow anon. msgs.—Select whether you want to reject
messages from an anonymous sender.
Receive adverts—Define whether you want to receive
multimedia message advertisements.
Receive report—Select whether you want the status of
the sent message to be shown in the log (network service).
Deny report sending—Select whether you want to deny
your device sending delivery reports of received messages.
Message validity—Select how long the message center
resends your message if the first attempt fails (network
service). If the message cannot be sent within the validity
period, the message is deleted from the message center.
E-mail
Press , and select Messaging > Options > Settings >
E-mail.
To select which mailbox you want to use for sending
e-mail, select Mailbox in use and a mailbox.
Select Mailboxes and a mailbox to change the following
settings: Connection settings, User settings, Retrieval
settings, and Automatic retrieval.
To remove a mailbox and its messages from your device,
scroll to it, and press .
To create a new mailbox, select Options > New mailbox.
Connection settings
To edit the settings for the e-mail you receive, select
Incoming e-mail and from the following:
User name—Enter your user name, given to you by your
service provider.
Password—Enter your password. If you leave this field
blank, you are prompted for the password when you try to
connect to your remote mailbox.
Incoming mail server—Enter the IP address or host name
of the mail server that receives your e-mail.
Access point in use—Select an internet access point (IAP).
See ‘Access points’, p. 122.
Mailbox name—Enter a name for the mailbox.
Mailbox type—Defines the e-mail protocol that your
remote mailbox service provider recommends. The options
are POP3 and IMAP4. This setting cannot be changed.