Filter
Top Products
Still image camera settings
To change the main settings, in the image mode, select
Options > Settings and from the following:
● Image quality — Set the resolution (main camera
only). The better the image quality, the more
memory the image consumes.
● Add to album — Save the image to an album in
Photos.
● Record location — To add GPS location coordinates
to each image file, select On. Receiving a GPS signal
may take time or the signal may not be available.
● Show captured image — Select whether to view
the captured image after it is taken or to continue
image capturing immediately.
● Default image name — Define the default name
for the captured images.
● Extended digital zoom — The setting is only
available in the main camera.On (continuous)
allows the zoom increments to be smooth and
continuous between digital and extended digital
zoom, On (paused) allows the zoom increments to
pause at the digital and extended digital step point,
and Off allows a limited amount of zoom while
retaining the image resolution. Use the extended
zoom only when getting closer to the subject is
more important than the final image quality. The
overall quality of a digitally zoomed image is always
lower than that of an unzoomed image.
● Capture tone — Set the tone that sounds when you
capture an image.
● Memory in use — Select where to store your
images.
● Restore camera settings — Restore the camera
settings to default values.
Color and lighting settings
In the active toolbar, select from the following:
● Flash mode (
) (image only) — Select the desired
flash mode.
● Color tone (
) — Select a color effect.
● Switch video light on or Switch video light off
— Switch the video light on or off (video mode
only).
● White balance (
) — Select the current lighting
condition. This allows the camera to reproduce
colors more accurately.
● Exposure compensation (
) (image only) — If you
are shooting a dark subject against a very light
background, such as snow, adjust the exposure to
+1 or +2 to compensate for the background
brightness. For light subjects against a dark
background, use -1 or -2.
● Sharpness (
) (image only) — Adjust the
sharpness of the image.
● Contrast (
) (image only) — Adjust the difference
between the lightest and darkest parts of the image.
38
Camera