Filter
Top Products
68 Other operator services
end the conference with
)
. At this point all calls are
disconnected. In order to make consecutive outgoing
calls, first initiate a normal call with the first number of
the conference. When the first member is on line, ini-
tiate a second call as described in “Make a second call”
above. When the second call is engaged, press
,
and
select
Conference
. Repeat the above process until five
members are connected.
If there is an incoming call during the conference call,
and if there is less than five members, you can accept
this new call by pressing
,
. Press
,
again and
then select
Conference
to add this member to the con-
ference call. If there is an incoming call during a con-
ference with five members already connected, you can
answer this new incoming call, but not add it to the
conference. While a conference call is in progress, press
,
to access the
Conf. members
options. Disconnect
a member of the conference by selecting
Remove party
and pressing
,
to confirm, or select
Private call
to
have a private call with this member only (other mem-
bers are put on hold)
Subscription dependent
You can connect an active call and a call on hold. You
are disconnected when the transfer is completed.
During a call press
,
, select
Tr a n s fer
and press
,
.
This feature is different from the Call forward, which
takes place before you pick up the call (see page 32).
Explicit Call Transfer
Philips330_EMEA_Ind3.book Page 68 Jeudi, 31. juillet 2003 3:48 15