c
Select Auto Calibration and press the [Enter] button.
The following screen appears.
d
Adjust the focus, if necessary, by opening the air filter cover on
the side of the projector and sliding the focus lever.
e
Select Yes and press the [Enter] button.
A pattern appears then disappears, and the system is calibrated. If
you see a message that calibration failed, you need to calibrate
manually.
The cursor location and pen position should match after calibration. If not,
you may need to calibrate manually.
Calibrating Manually
If the cursor location and pen position do not match after auto calibration,
you can calibrate manually.
a
Press the [Menu] button, select the Extended menu, and press
the [Enter] button.
Preparing Before Using Interactive Features
77
