Procedure
A
Press the [Screen Fit] button on the remote control or the
control panel.
Using the Remote Control Using the Control panel
When the following message box appears, move the projector to
adjust the position of the projected image, so that the message
box is at the center of the screen.
q
Correction cannot be performed unless the message box fits within
the screen frame. If you cannot make the message box fit inside
the screen frame even after adjusting the projector position or the
Zoom ring, correct the projected image manually.
B
Adjust the Zoom ring so that the projected area (defined by
outer white border line) is bigger than the screen frame.
If the projected area is still not larger than the frame even after
adjusting the Zoom ring to its maximum size, try moving the
projector further away from the screen. (If this causes the message
box moves away from the center of the screen, adjust it so that it
is centered again.)
C
Press the [Screen Fit] button again.
After the adjustment screen appears, the projected image is
corrected according to the
Aspect Ratio
g
of the inputted image.
q
Once the adjustment screen appears, do not move the projector or
block the image. The projected image will not be corrected properly
Correcting the Projected Image Using Screen Fit (EB-1925W/1915 Only)
24
