Sub Menu Function
Setting a Notification Event
You can select the problems or warnings to be notified about by e-mail. When the selected problem or warning occurs in the projector, an e-mail is
sent to the specified Destination address notifying that a problem or warning has occurred. You can select multiple items from the displayed items.
Others Menu
Sub Menu Function
SNMP Trap IP Address 1/
SNMP Trap IP Address 2
You can register up to two IP addresses for the
SNMP
g
trap notification destination.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP Addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be managed by a
network administrator.
Priority gateway
For the priority gateway, select either wireless or wired.
AMX Device Discovery
When the projector is connected to a network, set this to On to allow the projector to be detected by
AMX Device Discovery
g
. Set this to Off if
you are not connected to an environment controlled with a controller from AMX or AMX Device Discovery.
List of Functions
70
