When an ID is set for the projector and the remote control, you can
use the remote control to operate only the projector with a matching
ID. This is very useful when managing multiple projectors.
You can set an ID for the projector within a range of "1" to "9". The
default value is Off.
You can set an ID for the remote control within a range of "0" to "9".
The default value is "0". The following table shows the possible
combinations of projector ID and remote control ID.
Opera-
tion
Combinations Descriptions
Possible
Projector ID: 1 The projector ID and the
remote control ID are
identical, therefore you can
operate the projector with
the remote control.
Remote control ID: 1
Possible
Projector ID: Off When the Projector ID is
Off, you can operate with
the remote control
regardless of the remote
control ID setting.
Remote control ID: 1
Possible
Projector ID: 1 When the remote control ID
is "0", you can operate with
the remote control
regardless of the Projector
ID setting.
Remote control ID: 0
Not possi-
ble
Projector ID: 1 The projector ID and the
remote control ID do not
match, therefore you cannot
Opera-
tion
Combinations Descriptions
Remote control ID: 3
operate the projector with
the remote control.
Setting the Projector ID
Procedure
A
Press the [Menu] button, and then select Extended -
Projector ID from the Configuration menu.
s "Using the
Configuration Menu" p.52
Using the Remote Control Using the Control panel
Limitation of the Number of the Target Projectors when Using Multiple Projectors
42
