Page 6 Epson Research and Development
Vancouver Design Center
S1D13504 13504PLAY Diagnostic Utility
X19A-B-005-05 Issue Date: 01/02/01
Comments
• All numeric values are considered to be hexadecimal unless identified otherwise. For example,
10 = 10h = 16 decimal; 10t = 10 decimal; 010b = 2 decimal.
• Redirecting commands from a script file (PC platform) allows those commands to be executed as
though they were typed.
• The PC must not have more than 12M bytes of memory when used with the S5U13504B00C
board.
• Follow simultaneous display guidelines for correct simultaneous display operation.
• To determine if the CRT will operate correctly when using a dual panel, refer to the “Maximum
Frame Rates” table in the S1D13504 “Functional Hardware Specification,” document number
X19A-A-002-xx.
• When editing in 13504CFG with CRT enabled and panel disabled, select “Single Panel” from the
“Edit Panel Setup” submenu.
• When a CRT is enabled, the CRT settings will override the panel settings. If a panel is also used,
the CRT timing values will have to be changed to more closely match the panel's timing.
• A CRT cannot show 15 or 16 bits-per-pixel.
• Do not attach a panel with a 16-bit interface to the S1D13504 when a CRT is also attached.
Program Messages
ERROR: Too many devices registered.
There are too many display devices attached to the HAL. The HAL can only manage 10 devices
simultaneously.
ERROR: Could not register S1D13504 device.
A 13504 device was not found at the configured addresses. Check the configuration address using
the 13504CFG configuration program.
