Page 14 Epson Research and Development
Vancouver Design Center
S1D13504 13504DCFG Configuration Program
X19A-B-008-02 Issue Date: 01/02/01
The Panel Tab select the following panel settings.
Panel Tab
Single/Dual
Selects between a single and dual panel. If no panel exists,
select single.
Disable Half-frame Buffer
The half-frame buffer is used only for dual panels. Disabling the
half-frame buffer is not recommended as this will reduce the
display quality. Only available for dual panels.
Mono/Color
Selects between a monochrome and color panel. If no panel
exists, select color.
Format 2
Selects format 2 for 8-bit color passive LCD panels. For a
description of format 1 and format 2, see the
S1D13504
Hardware Functional Specification
, document number
X19A-A-002-xx.
STN/TFT Selects between a passive LCD and TFT panel.
EL Enable EL panel support.
Panel Interface
Selects the LCD panel interface width in bits. The bit width
values are different for STN and TFT panels.
FPLINE Polarity Selects the polarity of the FPLINE pulse.
FPFRAME Polarity Selects the polarity of the FPFRAME pulse.
Panel Dimensions Selects the width and height of the panel in pixels.
Non-Display Period Selects the HNDP in pixels and the VNDP in lines.
Frame Rate Selects the desired frame rate in Hz.
Pixel Clock Selects the desired pixel clock in MHz.
HRTC/FPLINE
Selects the start position and pulse width in pixels. Only
available for TFT panels.
VRTC/FPFRAME
Selects the start position and pulse width in lines. Only available
for TFT panels.
Predefined Panels
Selects configuration values from a list of predefined panels
listed in the file panels.cfg
