Page 90 Epson Research and Development
Vancouver Design Center
S1D13504 Hardware Functional Specification
X19A-A-002-18 Issue Date: 01/01/30
8 Registers
8.1 Register Mapping
The S1D13504 registers are all memory mapped. The system must provide the external address
decoding through the CS# and M/R# input pins. When CS# = 0 and M/R# = 0, the registers are
mapped by address bits AB[5:0], e.g. REG[00h] is mapped to AB[5:0] = 000000, REG[01h] is
mapped to AB[5:0] = 000001. See the table below:
8.2 Register Descriptions
Note
Unless specified otherwise, all register bits are reset to 0 during power up. Reserved bits should
be written 0 when programming unless otherwise noted.
8.2.1 Revision Code Register
bits 7-2 Product Code Bits [5:0]
This is a read-only register that indicates the product code of the chip. The product code is 000001.
bits 1-0 Revision Code Bits [1:0]
This is a read-only register that indicates the revision code of the chip. The revision code is 00.
Table 8-1: S1D13504 Addressing
CS# M/R# Access
00
Register access:
• REG[00h] is addressed when AB[5:0] = 0
• REG[01h] is addressed when AB[5:0] = 1
• REG[n] is addressed when AB[5:0] = n
01
Memory access: the 2M byte display buffer is addressed by
AB[20:0]
1X
S1D13504 not selected
Revision Code Register
REG[00h] RO
Product Code
Bit 5
Product Code
Bit 4
Product Code
Bit 3
Product Code
Bit 2
Product Code
Bit 1
Product Code
Bit 0
Revision
Code Bit 1
Revision
Code Bit 0
