A SERVICE OF

logo

5. BASE SPECIFICATIONS PARAMETERS
II - 79
(SETUP PARAM 1. 12/16)
# Items Details Setting range (unit)
1525 laxlen Not used.
1526 raxlen Not used.
1527 flclen Not used.
1528 rflch Not used.
1529 laxcmp Not used.
1530 raxcmp Not used.
1531 flccmp Not used.
1532 G01rsm Not used.
1533 millPax Pole
coordinate
linear axis
name
Set the linear axis used for pole coordinate
interpolation.
Control axis address
such as X, Y or Z
1534 SnG44.1 Spindle No.
for G44.1
command
Set the selected spindle No. for the G44.1
command.
0: 2nd spindle
1: 1st spindle
2: 2nd spindle
If a spindle that does
not exist is set, the
2nd spindle will be
used. Note that if
there is only one
spindle, the 1st
spindle will be used.
1535 C_leng Not used.
1537
to
1544
crsax[1]
to
crsax[8]
Not used.
(SETUP PARAM 1. 13/16)
# Items Details Setting range (unit)
1549 Iv0vr1 Not used.
1550 Iv0vr2 Not used.
1551 Iv0vr3 Not used.
1552 Iv0vr4 Not used.
1553 Iv0vr5 Not used.
1554 Iv0rd2 Not used.
1555 Iv0rd3 Not used.
1556 Iv0rd4 Not used.
1557 Iv0rd5 Not used.
1558 Iv0Min Not used.
1559 IvAMax Not used.
1560 IvFMin Not used.
1572 Cirorp Not used.
#1199 #1534 Selected spindle
0:G43.1 Not used. 1st spindle
1:G44.1 0 2nd spindle
1 1st spindle
2 2nd spindle
2:G47.1 Not used. All spindles