6. AXIS SPECIFICATIONS PARAMETERS
6.4 Axis Specifications Parameters 2
II - 97
# Items Details Setting range (unit)
2078 G1inps G1
in-position
width
When an in-position check is performed for G1, this
parameter is valid.
(Comparison of SV024 and this parameter, the
parameter that the in-position width is wider is applied.)
When 0 is set, this parameter is invalid.
(Applicable only to SV024)
0 to 32767 (µm)
2079 chcomp Chopping
compensa-
tion
coefficient
Set the coefficient applied on the compensation amount
for the insufficient amount caused by servo delay
during chopping.
0 to 10
(standard value: 8)
2080 chwid Bottom
dead center
position
width
Set the tolerance between the commanded stroke and
actual stroke.
During chopping, if the (command width - maximum
stroke of top/bottom dead center position /2) is within
this tolerance, compensation will be applied.
Least setting
increment =1µm:
0 to 10000 (µm)
Least setting
increment =0.1µm:
0 to 10000
(0.1 µm)
2081 chclsp Maximum
chopping
speed
Set the chopping axis clamp speed applied during
chopping.
Least setting
increment =1µm:
0 to 60000
(mm/min)
Least setting
increment =0.1µm:
0 to 60000
(0.1 mm)/min
2082 a_rstax Restart
position
return order
Designate the order for automatically returning to the
restart position.
0: Do not return.
When 0 is designated for all axes, all of the axes
will return simultaneously.
0 to 4
2084 G60_ax Unidirection
al positioning
operation
selection
Select the unidirectional positioning with G00.
Select the axis for carrying out the positioning per time
operation when the positioning command is issued
regardless of the unidirectional positioning command
and modal.
0: Carry out unidirectional positioning according to
the command and modal.
1: When the positioning command (G00) is issued,
carry out unidirectional positioning regardless of
the command and modal.
<Related parameters>
#8209 G60 SHIFT:
The final positioning direction and distance for
the unidirectional positioning command is set for
each axis.
#2076 Index table indexing axis:
Set the indexing axis for each axis.
0/1
