3. PROGRAM ERROR
I - 65
Error No. Details Remedy
P170 NO CORR. No.
The compensation number (DOO‚ TOO‚
HOO) command was not given when the
radius compensation (G41‚ G42‚ G43‚
G46) command was issued.
Alternatively‚ the compensation number
is larger than the number of sets in the
specifications.
• Add the compensation number command to
the compensation command block.
• Check the number of compensation number
sets a correct it to a compensation number
command within the permitted number of
compensation sets.
P172 G10 L-No. ERR
(G10 L-number error)
The L address command is not correct
when the G10 command is issued.
• Check the address L-Number of the G10
command and correct the number.
P173 G10 P-No. ERR
(G10 compensation error)
When the G10 command is issued‚ a
compensation number outside the
permitted number of sets in the
specifications has been commanded for
the compensation number command.
• First check the number of compensation sets
and then set the address P designation to
within the permitted number of sets.
P177 LIFE COUNT ACT
Registration of tool life management data
with G10 was attempted when the used
data count valid signal was ON.
• The tool life management data cannot be
registered when counting the used data. Turn
the used data count valid signal OFF.
P178 LIFE DATA OVER
The No. of registration groups‚ total No.
of registered tools or the No. of
registrations per group exceeded the
specifications range.
• Review the No. of registrations. The
maximum No. of registrations is shown
below.
No. of groups 80
No. of tools 80
Per group 16
P179 GROUP No. ILL.
• When registering the tool life
management data with G10‚ the group
No. was commanded in duplicate.
• A group No. that was not registered
was designated during the T
99
command.
• An M code command must be issued
as a single command but coexists in
the same block as that of another M
code command.
• The M code commands set in the same
group exist in the same block.
• The group No. cannot be commanded in
duplicate. When registering the group data‚
register it in group units.
• Correct to the correct group No.
P180 NO BORING CYC.
A fixed cycle command was issued
though there are not fixed cycle (G72 –
G89) specifications.
• Check the specifications.
• Correct the program.
