3. PROGRAM ERROR
I - 68
Error No. Details Remedy
P232 NO PROGRAM No.
• The specified subprogram is not
registered in the memory or IC card.
• The program file name registered in the IC
card and O No. do not match.
• Enter the subprogram.
• Check the program number in the IC card.
P241 NO VARl NUMBER
The variable number commanded is
higher than the numbers in the
specifications.
• Check the specifications.
• Check the program variable number.
P242 EQL. SYM. MSSG.
The "=" sign has not been commanded
when a variable is defined.
• Designate the "=" sign in the variable
definition of the program.
P243 VARIABLE ERR.
An invalid variable has been specified in
the left or right side of an operation
expression.
• Correct the program.
P252 PAT.&COOD-ROT
A coordinate rotation related command
(G68, G69) was issued during figure
rotation.
• Reconsider the program.
P260 NO COOD-RT SPC
Even though there were no coordinate
rotation specifications, a coordinate
rotation command was issued.
• Check the specifications.
P270 NO MACRO SPEC
A macro specification was commanded
though there are no such command
specifications.
• Check the specifications.
