3. PROGRAM ERROR
I - 71
Error No. Details Remedy
P380 NO CORNER R/C
A command was issued for corner
chamfering/corner rounding though there
are no such specifications.
• Check the specifications.
• Remove the corner chamfering/corner
rounding command from the program.
P381 NO ARC R/C SPC
Corner chamfering/corner rounding was
specified in the arc interpolation block
although corner chamfering/corner
rounding II is unsupported.
• Check the specifications.
P382 CORNER NO MOVE
The block next to corner chamfering/
corner rounding is not a movement
command.
• Replace the block succeeding the corner
chamfering/corner rounding command by
G01 command.
P383 CORNER SHORT
In the corner chamfering/corner rounding
command‚ the movement distance was
shorter than the value in the corner
chamfering/corner rounding command.
• Make the corner chamfering/corner rounding
less than the movement distance since this
distance is shorter than the corner chamfering/
corner rounding.
P384 CORNER SHORT
When the corner chamfering/corner
rounding command was input‚ the
movement distance in the following block
was shorter than the length of the corner
chamfering/corner rounding.
• Make the corner chamfering/corner rounding
less than the movement distance since this
distance in the following block is shorter than
the corner chamfering/corner rounding.
P385 G0 G33 IN CONR
A block with corner chamfering/corner
rounding was given during G00 or G33
modal.
• Recheck the program.
P390 NO GEOMETRIC
A geometric command was issued
though there are no geometric
specifications.
• Check the specifications.
P391 NO GEOMETRIC 2
There are no geometric IB specifications.
• Check the specifications.
P392 LES AGL (GEOMT)
The angular difference between the
geometric line and line is 1° or less.
• Correct the geometric angle.
P393 INC ERR (GEOMT)
The second geometric block was
specified by an incremental value.
• Specify this block by an absolute value.
P394 NO G01 (GEOMT)
The second geometric block contains no
linear command.
• Specify the G01 command.
P395 NO ADRS (GEOMT)
The geometric format is invalid.
• Recheck the program.
