ZENworks® ESM 3.5 Administrator’s Manual 101
VPN Enforcement
This rule enforces the use of either an SSL or a client-based VPN (Virtual Private Network). This
rule is typically applied at wireless hotspots, allowing the user to associate and connect to the
public network, at which time the rule will attempt to make the VPN connection, then switch the
user to a defined location and firewall setting. All parameters are at the discretion of the
administrator. All parameters will override existing policy settings. The VPN-Enforcement
component requires the user be connected to a network prior to launching.
Note:
This feature is only available in the ESM installation, and cannot be used for UWS security policies.
To access this control, open the Global Policy Settings tab and click the VPN Enforcement icon
in the policy tree on the left
Figure 77 : Basic VPN Enforcement
To add VPN enforcement to a new or existing security policy, perform the following steps:
Step 5: At LEAST two additional locations must be created, FIRST
Step 6: Check Enable to activate the screen and the rule
