IES-1000 User’s Guide
18-4 Maintenance
Table 18-3 Add Secured Client
LABEL DESCRIPTION
Secured
Client Setup
Click this link to go to the Secured Client Setup screen.
Secured
Client
Address
Set the IP address of a computer that you want to allow Telnet, FTP or Web access to this IES-
1000.
If you enter an IP address in this field, the IES-1000 checks if the client IP address of a
computer requesting a service matches the value here. The IES-1000 immediately disconnects
the session if it does not match.
Apply Click Apply to save your changes back to the IES-1000 's volatile memory. The IES-1000 loses
these changes if it is turned off or loses power, so use the Config Save link in the navigation
panel on the left to save your changes to the non-volatile memory when you are done
configuring.
Reset Click Reset to begin configuring this page afresh
18.2.2 Firmware Upgrade Screen
Click Maintenance in the navigation panel and then Firmware Upgrade in the Maintenance screen.
Use the Firmware Upgrade screen to upgrade the network module's firmware.
Do not interrupt the upgrade process, as it may permanently damage the network module.
The IES-1000 automatically restarts when the upgrade process is complete.
Procedure to upgrade your firmware:
Step 1. Use the network module’s Statistics screen to check its current firmware version number.
Step 2. Download and unzip the new firmware.
Step 3. Go to the Firmware Upgrade screen.
Step 4. Type the path and file name of the firmware file you wish to upload to the IES-1000 in the File Path
field or click Browse to display the Choose File screen from which you can locate it. After you have
specified the file, click Upload.
