IES-1000 User’s Guide
G.SHDSL Commands 25-9
networks.
The <rx vpi> and <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the rx
settings are not configured.
The set pvc command allows the configuration of a PVC (permanent virtual circuit) for an individual
G.SHDSL port.
25.3.18 Set PVCs Command
Syntax:
192.168.1.1 gshdsl> set pvcs <multiplexing mode> <tx vpi> <tx vci> [<rx
vpi> <rx vci>]
where
<multiplexing mode>=
Either “llc” or “vc”.
<tx vpi> =
The VPI setting of the G.SHDSL ports for use with a Tx based
network.
<tx vci> =
The VCI setting for the G.SHDSL ports for use with a Tx based
network.
<rx vpi> =
The VPI setting for the G.SHDSL ports for use with Rx based
networks.
<rx vpi> =
The VCI setting for the G.SHDSL ports for use with Rx based
networks.
The <rx vpi> and <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the rx
settings are not configured.
The set pvcs command allows you to configure a single PVC for all of the G.SHDSL ports at once.
25.3.19 Show PVC Command
Syntax:
192.168.1.1 gshdsl> show pvc <port #>
where
<port #> =
A port number, from 1 to 8.
This command allows you to display the PVC parameters of an individual G.SHDSL port. This command is
equal to the
show chs <port #> command (see section 26.3.5 Show Channels Command).
25.3.20 Show PVCs Command
Syntax:
192.168.1.1 gshdsl> show pvcs
This command allows you to display the PVC parameters of all G.SHDSL ports.
