IES-1000 User’s Guide
Commands Introduction 22-15
Table 22-1 Commands
MODULE COMMAND DESCRIPTION
ip
arp add <if> <ip> <mac>
Adds ARP record <ip> <mac> to
interface <if>.
delete <if> <ip>
Deletes ARP record <ip> from
interface <if>.
flush
Flushes all cached ARP records.
list
Lists all resolved ARP records.
help
Shows a help message for the ARP
command.
config
Shows the IP module’s run-time
configuration.
save
Saves the IP module’s configuration to
the nonvolatile memory.
enable [<if> [mtu <size> [<ip>
[<ipmask>]]]
Sets the IP address setting of the
specified interface.
device [list]
Lists interface definitions.
add <if> <type> <file> [mtu
<size>] [<IP> [mask <mask>]]
Adds a new interface.
delete <if>
Deletes the specified interface.
flush
Deletes all interfaces.
enable <if>
Enables the specified interface.
disable <if>
Disables the specified interface.
ping <host> [ttl [size]]
Does a ping test.
route
Displays all routing entries.
add <routeName> <ip> <relayIp>
[ <mask> [ <cost> [ <timeout>
]]]
Adds a routing entry.
delete <routeName>
Deletes a routing entry.
flush
Deletes all routing entries.
routes
Shows all routing entries.
stats help
Shows the help information about the
stats command.
arp [reset]
Shows or resets the ARP statistics.
icmp [reset]
Shows or resets the ICMP statistics.
ip [reset]
Shows or resets the IP statistics.
raw [reset]
Shows or resets the raw statistics.
tcp [reset]
Shows or resets the TCP statistics.
udp [reset]
Shows or resets the UDP statistics.
subnet add <netName> <if> <ip> <mask>
Creates a subnet.
