IES-1000 User’s Guide
22-8 Commands Introduction
Table 22-1 Commands
MODULE COMMAND DESCRIPTION
Disables 802.1X security on the
specified port.
control <port> <auto|auth|
unauth>
Sets how the specified port should be
authenticated.
Turns re-authentication on or off on
the specified port.
Configures how often the specified
port should be re-authenticated.
Displays 802.1X security status on the
specified port.
Sets the external RADIUS server IP
address.
Sets the external RADIUS server port
number.
secret <secret>
Sets the authentication and encryption
key.
show
Displays the external RADIUS server
settings.
edd
version
Displays Ethernet device driver
information.
test <ip>
Enables a ping-based Ethernet work
around.
set timeout [<# of minutes>]
Sets the Ethernet test timeout value.
ethernet set auto <on | off>
Enables/disables Ethernet port auto
negotiation.
duplex <full | half>
Sets the Ethernet port to full or half
duplex.
speed <100 | 10>
Sets the operating speed of the
Ethernet port (100M or 10M).
status
Shows Ethernet link status (auto-
negotiation, duplex, speed).
save
Saves Ethernet settings.
exit
Ends the console or telnet session.
flashfs
config
Displays the configuration of the flash
file system.
default
Shows the current partition.
Selects a partition as the current flash
file system.
