IES-1000 User’s Guide
System Commands 23-3
192.168.1.1 sys> set contact [<name>]
This command allows you to set the name of the contact person for your IES-1000. The previous setting will be
cleared if the command is entered with the name omitted.
23.3.4 Set Location Command
Syntax:
192.168.1.1 sys> set location [<name>]
This command allows you to set the location of your IES-1000. The previous setting will be cleared if the
command is entered with the location omitted.
23.3.5 Set Mode Command
Syntax:
192.168.1.1 sys> set mode <fast|normal>
where
fast =
Fast makes use of the “tag” subset of the IEEE 802.1Q standard to identify the
source port of a frame and speed traffic through a service gateway.
normal =
Normal switches frames using a layer 2 switch (IEEE 802.1D) transparent
bridge standard. Use normal mode when you are using a regular gateway.
This command lets you set the network module into fast or normal mode. Determine which mode you are
using by entering the info command. Fast mode allows only one port per PVID. Use normal mode and the
802.1Q VLAN commands (see Chapter 31 ) to configure VLANs or PVIDs with multiple ports.
Enable fast mode only when you are using a service gateway.
23.3.6 Set Slot Command
Syntax:
192.168.1.1 sys> set slot <slot number>
where
<slot number>=
This network module’s number in the IES-1000 chassis (1 or 2).
This command sets slot number of the network module. This is an optional parameter to help network
administrators keep track of individual network modules. Enter the command without the slot number to
display the network module’s slot number.
23.3.7 Set Chassis Command
Syntax:
192.168.1.1 sys> set chassis <chassis number>
