Filter
Top Products
8. NBDP PREPARATIONS
8-4
8. If you selected “Channel” at step 6, enter ITU channel number (see Appendix) or User
channel number.
9. If you selected “ScanTable” at step 6, press the → key to show scan group list
registered. For scan group, refer to paragraph 8.5.
10. Choose a scan group name by using the ↓ or ↑ key followed by pressing the Enter key.
Scanning Group List
INTREPID
VOYAGER
GLOBAL
▼
Scanning group list
11. Press the Enter key. The prompt OK/Cancel asks for verification of data.
O K
Cancel
OK/Cancel prompt
12. If the data are correct, press the Enter key. (To cancel entry, place the cursor on Cancel
by pressing the ↓ key, and then hit the Enter key. Data entered are erased.) The station
name entered at step 3 appears at the Station List window.
13. To register other stations, press the Enter key twice and then repeat steps 3 through 10.
14. Press the ↓ key. Check data on the Station List for correctness. Stations displayed in
reverse video on the Station List are displayed on Station Set Up.
15. Press the ESC key to quit.
Note 1: If you enter a station which already exists, the indication “Station by that
name already exists. Press any key to escape.” Appears. Press any key
to return to the Station List. Check the list.
Note 2: If you enter an invalid code, the message “Input Error. (ID Code) Press
any key to escape.” Appears. Press any key and reenter ID code.
8.2.2 Editing/Deleting stations
1. Press the function key F5 and then the 1 key.
2. Press the ↓ key to choose a station name from the Station List.
3. Press the → key followed by ↓ key to choose Change and press the Enter key.
4. Do one of the following;
Edit station: Use ↑, ↓ and the Backspace key to make corrections.
Delete station: Erase station name with the Backspace key.
5. Press the Enter key twice.
6. Press the Esc key.