Filter
Top Products
8. NBDP PREPARATIONS
8-6
8.3.2 Editing/Deleting timer programs
1. Press the function key F5 and the 2 key.
2. Choose a timer program name from the Timer Operation List.
3. Press the → key to choose Change and press the Enter key.
4. Do one of the following;
Edit program: Use ↑, ↓ and the Backspace key to make corrections.
Delete program: Erase operation name with the Backspace key.
5. Press the Enter key twice.
6. Press the Esc key.
8.4 User Channels
The user channel list provides storage for up to 100 user channels, numbered 0-99. Note
that user channels may be used in channel scanning.
8.4.1 Registering user channels
1. Press the function key F5 and then the 4 key to show the User Channel Entry screen.
User Channel Entry
Create
Change
Channel List
Channel Set Up
Channel : _
Tx Freq : 0.00
Rx Freq : 0.00
User channel entry screen
2. If Create is not underlined, press →, ↑ and the Enter key to underline it.
3. Channel is selected. Enter channel number.
Note 1: 100 channels may be registered. When you attempt to register more, the
message “Channel memory is full. Press any key to escape.” Appears. In this case
delete unnecessary channels to register new ones.)
Note 2: If the channel entered already exists, the message “Channel by that number
already exists. Press any key to escape.” Appears. Press any key and then reenter
number.
4. Press the ↓ key to choose “Tx Freq.” Enter TX frequency.
5. Press the ↓ key to choose “Rx Freq.” Enter RX frequency.
6. Press the Enter key. The ”OK/Cancel” confirmation window appears.
7. Press the Enter key. Channel number entered appears in the Channel List.
8. To quit, press the Esc key.