Filter
Top Products
11. MAINTENANCE & TROUBLESHOOTING
11-9
Setup
Slave Delay
TX/RX MSG Save
Edit Before sending
Time System
Time & Date
Window Color
Self Test
Lock Change Default
8 msec (0- 50 msec)
OFF O N
OFF O N
OFF UTC SMT JST
2006/10/16 10:00:00
System
System menu (Example: IB-583)
2. Choose Change from Setup.
3. Choose Self Test (at the bottom of the screen).
4. Press the Esc key. The results of the self test are displayed a short time later.
Selftest
Terminal Unit Test : ver. X.XX :OK
Main Unit Test : ver. XX :OK
Modem Unit Test : ver. XX :OK
Radio Unit Test : ID FS5070 :OK
DSC Unit Test : ID FS5070 :OK
Printer Unit Test* :
Print all character :OK
X.XX = Version No.
*: "NG" and "Printer not ready" when printer is off or
is abnormal.
IB-581/IB-583
Main Termina soft (T-CPU Board)
NBDP Modem
Self test results
The test results are shown as OK or NG (No Good). For any NG, try the self test again. If it
appears again, call for service. When the test is completed, the message “Selftest
Completed. Press any key to escape.” Appears.
Tone test
1. Choose Self Test from the System Menu.
2. While pressing and holding down the Shift key, press the ↓ key to show the Tone Test
menu.
Tone Test
1: Tone Test 1 (All Char)
2: Tone Test 2 (Fox)
3: Tone Test 3 (Beta)
44(k)
3. Choose a test and press the Enter key.
4. You may stop a tone test at anytime by pressing the Esc key.
Tone test 1 (All characters)
This test checks for proper transmission of all figures, letters and codes. To conduct the test,
call a station in the ARQ or FEC mode. Execute the test, confirming that all characters are
transmitted correctly. “Now Testing Tone Test 1” appears during the testing. Since the test is