Filter
Top Products
5. ROUTINE MESSAGE CALLING, RECEVING
5-7
No response! Try calling again?
Re-send call: Push the ENTER knob followed by pressing the CALL key.
Cancel call: Press the CANCEL key to go to DSC screen.
5.1.2 Receiving an individual call
Acknowledgement is able or unable depending on the comply-type setting (see section
6.11). The relationship between comply type and able/unable acknowledge is as shown in
the table below.
Setting for ACK/SQ key
ABLE UNABLE
AUTO ACK
Can send ABLE acknowledge
automatically
Can send UNABLE
acknowledge automatically.
MANUAL ACK
Send ABLE acknowledge
manually
Send UNABLE acknowledge
manually
Note: The handset must be on hook to enable automatic acknowledge.
Sending automatic acknowledge (ACK BQ) with comply type “ABLE”
When an individual call is received and the automatic acknowledge feature is active (AUTO
ACK) and the comply type is “ABLE,” the display shown below appears. This display
indicates that the auto acknowledge (ACK BQ) call is being sent.
Able acknowledge
message in progress!
TIME TO GO: 6S
DSC FREQ :
2177.0 kHz
DESTINATION ID:
123456789
PRIORITY : ROUTINE
TELEPHONE 2138.0 kHz
It takes about seven seconds to transmit the call, after which the audio alarm sounds and
the following message appears.
Able acknowledge
message transmitted.
CANCEL: STOP ALARM
PRIORITY: ROUTINE TX: 2138.0 kHz
TELEPHONE RX: 2138.0 kHz
1. Press the CANCEL key to silence the alarm. The following display appears.