Filter
Top Products
10. NBDP TRANSMITTING, RECEIVING
10-17
10.10 Automatic Telex using Macrofile
This section describes how to transmit a telex message using a macrofile.
Basic procedure
1. Register answerback code (Telex number assigned by coast station).
2. Register coast station frequency and channel to scan group.
3. Register station name including scan group name.
4. Retrieve appropriate macrofile. Include station name and message file name. Type
message and save file to memory.
5. Open macro operation menu and select a macrofile. Your message will be transmitted
automatically. Below is the sequence of automatic message transmission to a coast
station.
6. Search for free-signal
7. Call coast station on one of its radio channels
8. After connection is established, identity exchange
9. Transmission of service category and subscriber’s address
10. Transmission of message
11. Transmission of termination of message signal
a) Identity exchange
b) Clearing of radio circuit
Actual procedure
1. Press function key F3 to display the Operate menu.
1: Call Station
3: File to Send
4: Cancel Sending
5: Scan (Start/Stop)
6: Manual Reception
7: Timer Operation
8: Manual Calling
9: Set Frequency
Operate
2: Macro Operation
Operate menu
2. Press the 2 key to display the Call Macro screen.