Filter
Top Products
Appendix
90 nüvifone M20 Owner’s Manual
Change the Fuse in the
Vehicle Power Cable
CAUTION: When replacing the
fuse, do not lose any of the small
pieces and make sure they are put
back in the proper position.
If your device does not charge
in your vehicle, you may need to
replace the fuse located at the tip of
the vehicle adapter.
1. Unscrew the end piece, and
remove it.
2. Remove the fuse (glass and silver
cylinder), and replace with a 1A
fast blow fuse of the same size.
3. Ensure that
the silver tip
is located in
the end piece.
Screw on the
end piece.
Mount on Your
Dashboard
A mounting disk is included in
some nüvifone packages. Use the
mounting disk to mount your device
to the dashboard and comply with
certain state and local regulations.
CAUTION: The permanent
mounting adhesive is extremely
difcult to remove after it is
installed.
1. Clean and dry the dashboard
where you are placing the disk.
2. Remove the backing from the
adhesive on the bottom of the
disk.
3. Place the disk on the dashboard.
4. Remove the clear plastic cover
from the top of the disk.
5. Place the suction cup mount
on top of the disk. Flip the lever
down (toward the disk).
End
piece
Silver tip
Fuse
End
piece
Silver tip
Fuse