Filter
Top Products
©2001 Nokia Mobile Phones. All rights reserved.
244
Troubleshooting
If you use a cable connection, check that the cable is properly attached at both
ends.
If you use an infrared connection, check that the IR ports are facing each other and
the route between the ports is unobstructed.
Check that you are using the correct COM (serial) port on your PC.
For all other PC Suite problems, see the PC Suite guide and the PC Suite online help
‘Troubleshooting’ section.
15. Fax modem problems
When you use the communicator as a fax modem, make sure that the
communicator and the PC use the same baud rate. If you use the infrared
connection, the baud rate is set automatically. If you use the cable connection, set
the baud rate in the Fax modem settings. For the PC, the baud rate is set in the
connectivity software of the PC.
If you use the cable connection, fully compatible operation with all PC fax and
terminal software cannot be guaranteed. Consult your dealer. If you have problems
with your PC fax software, use the infrared connection.
If you have problems establishing a data connection with the remote modem, try
fixing the data transmission rate by using an AT command. Common AT commands
based on the ETSI 07.07 standard and supported by the Nokia 9210 Communicator
are listed in the atcomm.txt file on the CD-ROM supplied with the communicator.
For information on how to use the AT commands and fax modem drivers, consult
the documentation of the telecommunication or fax application that you use on
your PC.