FOAMPRO® F1000
17
©2001 R11.01
STARTUP | CALIBRATION
2.2
of air flowing through the system. Different uses of the F1000, for example spraying
foam, may require a higher flow of air than pouring foam. Experience in using the
F1000 will help the user determine what air flow level suits their needs.
Once the proper amount of airflow through the Air Injection System has been
achieved, the F1000 dispenser is ready for use. Foam product can be dispensed by
depressing the trigger.
After using the F1000 dispenser, if it is to momentarily sit idle for more than a few
minutes, either let air flow through the Air Injection System, or place a few drops of
solvent into the open end of the plastic nozzle. Keep the plastic nozzle pointed
upward so the solvent remains and prevents any foam product from curing in the
end of the nozzle or mix cartridge. If the F1000 dispenser is to be shut down or
stored for a long period of time, follow the procedure for Shutdown described in
Section 4.1.
Diagram 17A
Diagram 17B
