9 - AUX PAGES
184
190-00357-00 Rev C
4. Press ENT to accept the selected offset.
NOTE: When a local time offset is entered, you
must also select “Local 12 hour” or “Local 24
hour” time format. The “UTC” time format setting
ignores any time offset entry.
Display Backlight.
To change the backlighting intensity:
1. Select “Display Backlight” from the Setup
Page.
2. The flashing cursor highlights the backlight
“Mode” field. Turn the small right knob to
select the desired mode: Auto or Manual. Press
ENT to accept the selection.
3. If “Manual” is selected, the flashing cursor
moves to the backlight “Level” field. Turn the
small right knob to select the desired level.
Press ENT to accept the selection.
Nearest Airport Criteria
To set the minimum runway length and runway
surface:
1. Select “Nearest Airport Criteria” from the Setup
Page.
2. The flashing cursor highlights the “Runway
Surface” field. Turn the small right knob
to select the desired surface. The following
options are available:
•Any surface
•Hard surfaces Only
•Hard / Soft surfaces
•Water landings only
3. Press ENT to accept the runway surface selec-
tion.
4. The flashing cursor moves to the minimum
runway length field. To enter a different mini-
mum runway length, use the small and large
right knobs to enter the desired length. Press
ENT when finished.
A runway length of “0”(or a very short length)
will report all available runways.
Setup 1 Page
