Filter
Top Products
Rockwell Automation Publication 150-QS003D-EN-P - November 2013 33
Chapter
3
Programming
Parameter Configuration/
Programming
Parameter Configuration using the Cat. No. 150-SM6 Parameter
Configuration Module (PCM)
The Cat. No. 150-SM6 PCM provides simple and limited configuration of the
SMC-50. This PCM can be inserted into any control module option port (7, 8,
or 9). Only one PCM is allowed per control module.
Parameters that are configured by the PCM will appear as read-write parameters
to other configuration devices and whose values represent the switch settings.
The parameter values set by the PCM are stored in the control module memory.
Therefore, using the appropriate removal procedure (remove all power to
Control Module and Power Module), the PCM can be removed from the control
module with its parameter settings retained.
When using a Cat. No. 150-SM6 PCM to configure the SMC-50, it should be
noted that the following features, functions, and modes are not configurable:
• Full voltage start
• To r que r a m p s ta r t
• External brake stop
• Option card I/O configuration (Cat. No. 150-SM… option modules)
• External bypass
• Specialized output relay configuration (e.g., network control,
DeviceLogix, auxiliary control)
• Specialized operation modes/features
– Dual ramp, motor winding heater, emergency run
– Overload select (Class)
– Adjustment of slow speed set point
Parameters that are not defined and therefore are not configurable by the Cat.
No. 150-SM6 PCM can be configured through other means (e.g., Human
Interface Module (HIM), Connected Components Workbench (CCW),
DriveExplorer or DriveExecutive software), if necessary.