Filter
Top Products
Introduction
13
1999 Nokia Mobile Phones. All Rights Reserved.
Facts about your communicator
Services
The GSM system provides a number of various wireless services, but they are
not automatically enabled to the wireless phone user. Even though the Nokia
9110 Communicator represents the latest development in wireless phone
technology, using its various communications applications requires that you
have subscribed to these services and that your network operator has
activated these services for you. Services that need to be subscribed to are
typically the short message service, Internet and fax.
Because the number of special services depends on what services are available
in your home network, it is, unfortunately, impossible to provide a
comprehensive list of the services and settings you need in this manual.
Therefore, this manual gives general information about the additional
services. Please, contact your network operator for further information about
the availability and the details of services in your home network.
If a service requires a separate phone number or specific settings, they must
be stored in the settings of the communicator. For example:
Sending and receiving short messages requires that this service is supported
by the network you are using and activated for your SIM card, and that the
phone number of the message centre is stored in the settings of the SMS
application.
Internet access requires that data service is supported by the network you are
using and activated for your SIM card. In addition, you must have obtained an
Internet access point from an Internet service provider.
Access codes
The Nokia 9110 Communicator uses several access codes to protect against
unauthorised use of your communicator and SIM card. The access codes you
need most often are the lock code, which is provided in the sales package, and
the PIN code, which is provided with the SIM card.
You can change access codes that are used by both the phone and the
communicator interface via either of them, provided that the code can be
changed. For more details on the access codes, see ”Security” on page 127.
The Internet applications of the communicator use passwords and user names
to protect from unauthorised use of the Internet and its services. These
passwords are changed in the settings of the Internet applications.
Note: In this manual, the names of
the commands on the display are in
bold and the settings and options
are in italics.