Filter
Top Products
Copyright © 2003 Nokia. All rights reserved.
Settings
32
Tip! The Settings
wizard program included
in the PC Suite for Nokia
3660 can help you to
configure access point
and mailbox settings. You
can also copy existing
settings, for example,
from your computer to
your phone. See the CD-
ROM supplied in the sales
package.
Minimum settings needed to make a data call
• To insert a set of basic GSM data call settings, go to Settings→ Connection→ Access
points and select Options→ New access point. Fill in the following: Data bearer: GSM
data, Dial-up number, Session mode: Permanent, Data call type: Analogue, and Maximum
data speed: Automatic.
High speed data call (High Speed Circuit Switched Data, HSCSD)
Glossary: High-speed data enables data transmission rates to a maximum of 43.2
kbps, which is three times faster than the standard data rates of the GSM network.
HSCSD is comparable to the speed of many computer modems that communicate
with today's fixed telephone networks.
For availability and subscription to high-speed data services, please contact your network
operator or service provider.
Note: Sending data in HSCSD mode may drain the phone’s battery faster than
normal voice or data calls, as the phone may send data more frequently to the
network.
Packet data (General Packet Radio Service, GPRS)
Glossary: Packet data, or General Packet Radio Service (GPRS), uses packet data
technology where information is sent in short bursts of data over the mobile
network. The benefit of sending data in packets is that the network is occupied
only when sending or receiving data. Because GPRS uses the network efficiently,
it allows for quick data connection set up and fast data transmission speeds.
Minimum settings needed to make a packet data connection
• You need to subscribe to the GPRS service. For availability and subscription to GPRS,
contact your network operator or service provider.
•Go to Settings→ Connection→ Access points and select Options→ New access point.
Fill in the following: Data bearer: GPRS and Access point name: enter the name given to