Filter
Top Products
To lock the keypad in the
standby mode, press the left
selection key and *. To unlock,
press the left selection key and
* again.
Tip: To lock the keypad
in the Menu or in an
open application, press
the power key briefly,
and select Lock keypad.
To unlock, press the left
selection key and *.
You can also lock the device in
the standby mode using your
lock code. Press the power key,
select Lock phone, and enter your lock code. To unlock,
press the left selection key and *. Enter your lock code,
and press the joystick.
Connectors
Warning: When you use the headset, your ability
to hear outside sounds may be affected. Do not use the
headset where it can endanger your safety.
Battery
charger
connector
Pop-Port
connector for
headset and
other
enhancements
Antennas
Your device has two internal antennas.
Note: As with any other radio transmitting
device, do not touch either of the antennas
unnecessarily when the device is switched on. Contact
with the antenna affects call quality and may cause the
device to operate at a higher power level than
otherwise needed. Not touching the antenna area
during a phone call optimises the antenna performance
and the talktime of your device.
16
Get started
Cyan
Cyan
Magenta
Magenta
Yellow
Yellow
Black
Black
file:///C:/USERS/MODEServer/grawei/29555801/rm-10_zeus/en/issue_2/rm-10_zeus_en_2.xml Page 16 May 22, 2006 5:43:34 AM
Cyan
Cyan
Magenta
Magenta
Yellow
Yellow
Black
Black
file:///C:/USERS/MODEServer/grawei/29555801/rm-10_zeus/en/issue_2/rm-10_zeus_en_2.xml Page 16 May 22, 2006 5:43:34 AM