Filter
Top Products
Using Speed Dialing
With this feature, you can dial your favorite entries using one key press
for locations 2-9. (See “Assigning Speed Dial Numbers” on page 96.)
To use speed dial for voice calls:
ᮣ
From standby mode, press and hold the appropriate key for
approximately two seconds.
– or –
ᮣ
From standby mode, press the appropriate key and
press or .
The display confirms that the number has been dialed when it shows
“Connecting...”.
To use speed dial for Ready Link calls:
ᮣ
From standby mode, press the appropriate key then press and
hold . (See “Assigning Speed Dialing for Ready Link Entries”
on page 154.)
The display confirms that the number has been dialed when it shows
“R-Link calling...”.
Note:Speed dialing is not available when you are roaming; when you are
roaming off the network provided to you, you must always dial using eleven digits
(1 + area code + number).
Using Abbreviated Dialing
Abbreviated Dialing is another form of speed dialing. It allows you to
dial a number by entering the last 3-6 digits of any number in your
Contacts directory. This feature becomes available when you set the
abbreviated dialing enable and enter the appropriate digits of a
phone number. See page 60 for the setting.
To place a call using Abbreviated Dialing:
1. Dial the last 3-6 digits of a contact’s phone number.
2. Press Options (right softkey) to display the dialing options.
3. Highlight Abbrev. Dial and press , , or .
Tip:You can also place a call by pressing or during step 2 above.
Note:If there is no matched number, your phone dials the number you set for
abbreviated dial with the last four or five digits you entered. If there are matched
numbers in your Contacts list, the abbreviated dial list will be displayed. To place
a call, select a number and press .
Section 2A: Your Phone – The Basics 31