Filter
Top Products
R290 User’s Guide
28
4. Enter the unit cost. An example of how this should be entered is 2, 5,
0, 0 for the unit charge of £2.50.
5. Press SOFT LEFT to move the cursor to the Currency field and
select a currency using the <* or #> key. If you do not change the
default currency, the phone will use that indicated by the current SIM.
6. Once the cost and currency information has been entered, press YES.
You may be prompted for the SUPER PIN if you are using a Phase 2
SIM, or the PHONE PIN if you are using a Phase 1 SIM.
NOTE:
If the SUPER PIN is entered incorrectly three times, the message ‘Super
PIN Blocked’ will be given and all SUPER PIN protected features will
become inaccessible. If the PHONE PIN is entered incorrectly three
times, the message ‘Call Rate Change Disabled’ will be given.
After the requested PIN has been entered correctly, the confirmation
message ‘Request Accepted’ will be given before returning to stand-by.
Once the PIN has been accepted, the message Request Accepted will be
given before the phone returns to the stand-by display.
If the unit time and cost have been set up and if Advice of Charge has
been subscribed to, it will be used in preference.
If you are only subscribed to Advice of Charge Charging (AOCC) but the
network you are using does not support it you will not be able to make
chargeable calls.
If the maximum number of units has been reached (the Accumulative Call
Meter Maximum), you will be unable to make chargeable calls. If you are
currently in an outgoing chargeable call, this will be shut down.
If the unit cost has not been set up, the total number of call units will still
be stored so that the unit cost may be added later in order to calculate the
costing information.
If the unit cost is replaced, the cost of all units will be re-calculated.
Call meters may be reset, but if a Phase 1 SIM is being used, they are
Phone PIN protected, or if a Phase 2 SIM is being used, they will be Super
PIN protected.
To Setup the Unit Time for Calls
1. Press SOFT LEFT, then 2, to enter the Call Time Menu.
2. Press 4 to display the Cost Setup menu.