Filter
Top Products
Make calls
109
Accept—to activate the sharing session.
Reject—to decline the invitation. The sender receives a
message that you rejected the invitation. You can also
press the end key to decline the sharing session and
disconnect the voice call.
When you are receiving a video clip, to mute the sound of
the clip, select Mute.
To end video sharing, select Stop. Video sharing also ends
if the active voice call ends.
Answer or decline a call
To answer the call, press the call key, or open the slide.
To mute the ringing tone when a call comes in, select
Silence.
If you do not want to answer a call, press the end key. If
you have activated the Call divert > If busy function to
divert calls, declining an incoming call also diverts the call.
See ‘Call divert’, p. 119.
When you select Reject to reject an incoming call, you can
send a text message informing the caller that you cannot
answer the call. Select Options > Send text message. To
set up this option and write a standard text message, see
‘Call’, p. 118.
Answer or reject a video call
When a video call arrives, is displayed.
Press the call key to answer the video call. Allow video
image to be sent to caller? is displayed. To start sending
a live video image, select Yes.
If you do not activate the video call, video sending is not
activated, and you only hear the sound of the caller. A grey
screen replaces the video image.
To replace the grey screen with a still image captured by
the camera in your device, see ‘Call’, Image in video call,
p. 118.
To end the video call, press the end key.
Call waiting
You can answer a call while you have another call in
progress if you have activated Call waiting in Tools >
Settings > Phone > Call > Call waiting (network service).
To answer the waiting call, press the call key. The first call
is put on hold.
To switch between the two calls, select Swap. To connect
an incoming call or a call on hold with an active call and
to disconnect yourself from the calls, select Options >
Transfer. To end the active call, press the end key. To end
both calls, select Options > End all calls.