Filter
Top Products
Settings
123
• Pre-shared key (only for Pre-shared key)—Enter a
password. The same password must be entered on the
wireless LAN access point device.
• WPA2 only mode (only for WPA/WPA2)—Select
whether Temporal Key Integrity Protocol (TKIP) is used.
Homepage—Define a home page.
Select Options > Advanced settings and from the
following:
IPv4 settings: Phone IP address (the IP address of your
device), Subnet mask (the subnet IP address), Default
gateway (the gateway), and DNS address. Enter the IP
addresses of the primary and secondary DNS server.
Contact your internet service provider for these addresses.
IPv6 settings > DNS address—Select Automatic, Well-
known, or User defined.
Ad-hoc channel (only for Ad-hoc)—To enter a channel
number (1-11) manually, select User defined.
Proxy server address—Enter the address for the proxy
server.
Proxy port number—Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data connection—If you select When available
and you are in a network that supports packet data, the
device registers to the packet data network. Starting an
active packet data connection (for example, to send and
receive e-mail) is quicker. If there is no packet data
coverage, the device periodically tries to register to the
packet data network. If you select When needed, the
device uses a packet data connection only if you start an
application or action that needs it.
Access point—The access point name is needed to use your
device as a packet data modem to your computer.
Wireless LAN
Show WLAN availability—Select whether is displayed
when a wireless LAN is available.
Scan for networks—If you set Show WLAN availability to
Yes, select how often the device searches for available
wireless LANs and updates the indicator.
To view advanced settings, select Options > Advanced
settings. Changing wireless LAN advanced settings is not
recommended.
Data call
Select User defined or Unlimited to define the time-out
period after which data call connections automatically end