Filter
Top Products
Settings
122
Phone IP address (for IPv4 only)—Enter the IP address of
your device.
DNS address—In Primary DNS address, enter the IP
address of the primary DNS server. In Secondary DNS
address, enter the IP address of the secondary DNS server.
Contact your internet service provider to obtain these
addresses.
Proxy server address—Define the address for the proxy
server.
Proxy port number—Enter the proxy port number.
Wireless LAN access points
Follow the instructions from the wireless LAN service
provider.
WLAN network name—Select Enter manually or Search
for networks. If you select an existing network, WLAN
network mode and WLAN security mode are determined
by the settings of its access point device.
Network status—Defines whether the target network is
hidden or not.
WLAN network mode—Select Ad-hoc to create an ad hoc
network and to allow devices to send and receive data
directly; a wireless LAN access point device is not needed.
In an ad-hoc network, all devices must use the same
WLAN network name.
WLAN security mode—Select the encryption used: WEP,
802.1x (not for ad hoc networks), or WPA/WPA2. If you
select Open network, no encryption is used. The WEP,
802.1x, and WPA functions can be used only if the network
supports them.
WLAN security settings—Enter the settings for the
selected security mode:
Security settings for WEP:
• Wep key in use—Select the WEP key number. You can
create up to four WEP keys. The same settings must be
entered on the wireless LAN access point device.
• Authentication type—Select Open or Shared for the
authentication type between your device and the
wireless LAN access point device.
• WEP key settings—Enter WEP encryption (length of
the key), WEP key format (ASCII or Hexadecimal), and
WEP key (the WEP key data in the selected format).
Security settings for 802.1x and WPA/WPA2:
• WPA/WPA2—Select the means of authentication: EAP
to use an extensible authentication protocol (EAP)
plug-in, or Pre-shared key to use a password.
Complete the appropriate settings:
• EAP plug-in settings (only for EAP)—Enter the settings
as your service provider instructs.