Filter
Top Products
2. SYSTEM INITIALIZATION
2-6
Note: The terminal unit must be “idle” to login. (“Current State: IDLE”
appears at the bottom of the screen.) When it is not idle, “Ignored:
MES is not idle.” appears. Press the [Esc] key to return to the standby
display. Wait until the terminal unit becomes idle.
4. Yes is selected; press the [Enter] key to start login.
5. Login begins and the screen should now look something like the illustration
below, with “LOGIN” flashing.
Current State: LOGIN
CALLING
DCE F16 Ver. **
02-02-25 02:02 (UTC)
LAT: 34:30.00N
LON: 135:30.00E
LOGIN replaces IDLE.
Flashing during login
SYNC ( NCS )
NCS: IOR LOGIN
Options
Login
Starting Login Process.
Press any key to escape.
File Edit Transmit EGC Reports Logs Options Setup Position StopAlarm
Appearance of display screen during login
When login is completed, the message “Successful login.” appears. Then,
the terminal unit goes into “Idle” status and LOGIN stops blinking.
6. Press any key to return to the standby display.