Filter
Top Products
Powering-On the Phone
Turning the Phone On
*
Press and HOLD (On-Off) to turn On the phone.
The screen displays mMode animation during the powering-on process.
After the powering On process, the phone displays the Idle screen.
You may need to input your PIN1 code or phone security code (refer to page 15).
Turning the Phone Off
*
Press and HOLD (On-Off) until it powers down. The power down screen displays the
NEC High Definition Mobile graphic and the phone powers Off.
After powering Off or turning the wireless phone Off, you must wait three seconds before
powering On.
Language Display
If the display is showing any language other than your own, proceed as follows:
*
Press Softkey 1 (Main) to display the Main Menu. Press 1, 2, and 5 to display the Language screen. (See Flag.)
Press the appropriate key to select the required language.
Press (End) to return to the Idle screen.
Frequency Bands
The type of frequency band that you use depends upon your location. (See Flag.)
*
Press Softkey 1 (Main),1,5,and 4 to display Band screen.
Press 1 to select the 850/1900 frequency band if you are located in the United States or
press 2 to select the 900/1800 frequency band if you are located in Europe.
O
Do not remove the battery to turn
your phone Off as this may cause
loss of stored information.
O
The phone supports the above
languages and the keyboard
symbols have been chosen for
world-wide operation.
O
Frequency bands need to be
changed for the wireless phone to
work properly when traveling
outside the United States.
AT&T Wireless
Language
M125
19