Filter
Top Products
-101- Connecting your 338 to a PC
To Establish a Dial-up Connection to a PC using a USB Cable
Do the following on your 338:
This service is currently not available in the UK.
Do the following on the PC:
Please ensure your 338 and the PC are connected via USB cable before proceeding.
Data exchange
Data exchange is used to allow the transfer of data files between the phone memory and a PC.
To use this functionality, you must first install the 338 PC File Transfer Tool. To install the software, refer to the Software
manual on the optional CD-ROM accessory.
You cannot use any other applications while data is being exchanged between your 338 and a PC.
To Do this
1 Connect the 338 and the PC with a USB
cable
Insert the USB cable to the I/O connector of the 338 and the USB
connector on the PC.
The USB cable and PC CD software for the 338 are available as
optional accessories from 3.
Insert the USB cable vertically to the 338 (do not insert it at an
angle).
2 Dial up From the PC application, start the dial-up. A connection is established.
3 Disconnect Disconnect from the PC application.
To Do this
1 Add a new connection on PC Using Microsoft Dial-Up Networking, add a new connection ensuring the
device used to make the connection is the NEC 338 Modem.
Also ensure that the telephone number to dial is set to *99#
This procedure only needs to be performed once.
2 Dial Connect using this dial-up connection
3 Start the Internet communication After connection is made, start up and use the appropriate Internet
application (browser, mailer, instant messenger, etc.)